Engine, with filter » 5 quarts
[1]Cooling System, With AC Initial Fill » 6.9 quarts
Passenger Car & Light Truck Antifreeze & CoolantAMSOIL Antifreeze and Engine CoolantCooling System, Without AC Initial Fill » 6.3 quarts
Passenger Car & Light Truck Antifreeze & CoolantAMSOIL Antifreeze and Engine CoolantAutomatic Transmission, A4LD Initial Fill » 3 quarts
Automatic Transmission, Total Fill
4 speed RWD A4LD » 9 quarts
4 speed 4WD A4LD » 10 quarts
Manual Transmission, 4-SPD » 3 pints
Manual Transmission, Mazda (5-SPD) » 5.9 pints
[2]Manual Transmission, Mit (5-SPD) » 4.9 pints
Differential, Dana 28 Front » 1.1 pints
[3]Differential, Dana 35 Front » 3.6 pints
Differential, Rear » 5.1 pints
[4]Transfer Case, U/K TRC » 3 pints
ANTPC ANT ANTPC ANT
Capacities Comments [1] When refilling, remove dipstick to provide adequate venting
and allow oil to flow into crankcase. After refill, check
oil level. Top off to proper level as needed.
[2] The drain plug on the Mazda transmission is at the rear of
the pan. Drain plug on the Mitsubishi transmission is at the
center of the pan.
[3] With Dana 28: If fill hole is at centerline of
axle must have lube level
no higher than 1/2 inch below fill hole. Models
with fill plug below centerline of axle must have
lube level no higher than 1/8 inch below fill hole.
[4] Fill to no more
than 1/4 to 9/16 inch below fill plug hole.